[Documentation] [TitleIndex] [WordIndex] 

Only released in EOL distros:  

Package LinksDependencies (7)
Used by (1)

Package Summary

Documented

rl_env is is a package containing reinforcement learning (RL) environments.

Contents

  1. Documentation
    1. Running an environment
      1. Example
    2. How the Environment interacts with the RL Agent
      1. Using rl_msgs
      2. Calling methods directly

Documentation

Please take a look at the tutorial on how to install, compile, and use this package.

Check out the code at: https://github.com/toddhester/rl-texplore-ros-pkg

This package contains a variety of environments that can be used for reinforcement learning experiments. These can be used with new RL agents written to use the rl_msgs framework, or with existing agents from the rl_agent package. The package contains the following environments:

All of these domains can be run in stochastic or deterministic mode by passing the --deterministic or --stochastic options. The two room gridworld and mountain car tasks can also be run with action delays by passing --delay n. The robot car velocity control simulation is a simulation of controlling the pedals of UT's autonomous car to control its velocity. This simulation simulates a single 20 Hz step when called, but actions do not have to be specified at 20Hz (as they do on the actual robot car or in the Stage simulation of it).

Running an environment

The environment can be run with the following command: 

rosrun rl_env env --env type [options]

where the environment type is one of the following options: 

taxi tworooms fourrooms energy fuelworld mcar cartpole car2to7 car7to2 carrandom stocks lightworld

There are a number of options to specify particular parameters of options for the various domains:

Example

As an example, to run the car velocity control task, with the car learning to go between random starting and target velocities, with stochastic actions, lag on the brake actuator, and debug print statements on, you would call: 

rosrun rl_env env --env carrandom --lag --stochastic --prints

How the Environment interacts with the RL Agent

The environment can interact with an RL agent in two ways. It can use the ROS messages defined in rl_msgs, or another method can call the agent and environment methods directly, as done in the rl_experiment package.

Using rl_msgs

The rl_msgs package defines a set of ROS messages for the agent and environment to communicate. These are similar to the messages used in RL-Glue (Tanner and White 2009), but simplified and defined in the ROS message format. The environment publishes three types of messages for the agent:

The environment subscribes to one type of message from the agent:

When the environment is created, it sends an RLEnvDescription message to the agent. Then it will send any experience seeds for the agent in a series of RLEnvSeedExperience messages. Then it will send the agent an RLStateReward message with the agent's initial state in the domain. It should then receive an RLAction message, which it can apply to the domain and send a new RLStateReward message. When the episode has ended, the environment will receive an RLExperimentInfo message from the agent, and it will reset the domain and send the agent a new RLStateReward message with its initial state in the new episode.

Calling methods directly

Experiments can also be run by calling the agent and environment methods directly (as done in the rl_experiment package). Methods that all environments must implement are defined in the Environment interface in the rl_common package (API). Seeds can be retrieved from the environment with the getSeedings() method. An action is applied to the environment with a call to apply(action). The current state can be retrieved by calling sensation() and terminal() will indicate if the agent is in a terminal state or not.

References

2024-11-09 14:47